Inductive Proximity switch

A wide range of inductive proximity switches are manufactured by us, which is indispensable component of machinery that operates under the extreme environment conditions like dust, oil, and corrosion. These are solid state switching devices that do not require physical contact for actuation. Proximity Switches are solid state switching devices based on Eddy Current Loss Principle. These are Suitable for direct connection to conventional as well as electronic control systems, and can be used for controlling and positioning signals. An alternating electromagnetic Field is developed at the sensing face of the proximity switch. When any metallic object enters this field the eddy current increase.

The specifications of this range are as follows:

• These products are available as M8, M12, M18, M25, M30, M40.
• 1 No. + 1 NC and short circuit protection available on request.
• All switches are flush or non- flush type.
• 2 wire switches also available.

A wide range of Circular Loom Photocell is offered by us, which is a photocell aligned on the rellector holder in such a way that bobbin or broken welf tape is sensed through the self adhesive reflector and gives required signal to activate the relay. This range of photocell works on visible light source, hence making the alignment simpler.

The technical specifications of this range are as follows:

• Voltage : 10 - 30 V A.C/ D.C
• O P : NPN - NO or direct relay drive 100 rnA short circuit and Reverse polarity protected.
• Response : 0.4 sec (off delay 2 sec for circular loom application)
• Repetition : 1 Khz
• Rate : (For High speed application)